Laser Show Systems - Pinouts

Home Page >>> Backstage Area >> Laser Show Systems > Pinouts

Introduction

System Design

Scanning Systems

Support Equipment

Laser Graphics

Show Production

Pinouts

Laser Show Systems - Pinouts

DISCLAIMER: The pinouts shown here were contributed by manufacturers, vendors and individuals. While every effort has been made to insure accuracy, LaserFX.com can not be responsible for any errors or omissions.

Divine LightWave Technologies - DLT 9370 Scan Amplifier

Pinout for the DLT 9370 single axis scan amplifier used for CT6800 series galvos. This is not an official DLT document. For more information, contact DLT directly.

Pin Number	Signal
1	Ground
2	+24 VDC
3	-24 VDC
4	Aux position input
5	Ground
6	Negative drive output -
7	Positive drive output +
8	Ground
9	Positive scan signal input +
10	Negative scan signal input -
11	Position test point
12	SO Speed Control input
13	S1 Speed control input
14	Temperature flag output
15	Ground
16	AGC out
17	1B input
18	1A impute
19	Ground
20	N/C
21	N/C
22	Ground

Jumper Settings

Speed	Jumper
Fast	S0 and S1 both installed
Medium	S1 only installed
Slow	S0 only installed
MA	No jumpers [see note]

NOTE: If both jumpers are removed, there is no signal applied to the board but the amplifier is powered up. This allows you to do mechanical alignment of the scanner in the mount.

DISCLAIMER: Some of the information in the Backstage area is provided by the persons or companies named on the relevant page(s). Laser F/X does NOT endorse or recommend any products/services and is NOT responsible for the technical accuracy of the information provided. We provide this information as a service to laserists using the Backstage area.

[ Introduction - System Design - Scanning Systems - Support Equipment - Laser Graphics - Show Production - Pinouts ]

	� 1996-2008 Laser F/X International and LaserFX.com - All rights reserved. Logos and trademarks are the property of their respective owners - used by permission.