Home Page >>> Backstage Area >> Laser Show Systems > Pinouts

Laser Show Systems - Pinouts

    This section contains pinouts of many popular boards and components that are used in laser show systems.

DISCLAIMER: The pinouts shown here were contributed by manufacturers, vendors and individuals. While every effort has been made to insure accuracy, LaserFX.com can not be responsible for any errors or omissions.

• 60X Umbilical - Pinout for the umbilical connector on the popular 60X type lasers - contributed by O. Steven Roberts

• 6800HP - Pinout for the connector on the Cambridge Technology 6800HP high speed galvo.

• ALC 68 - American Laser model 68 umbilical pin out and colour code

• Accelerator124 - Card edge connector and on-card controls for LSDI's card designed to drive open loop galvos at speeds up to 12K

• Cambridge Technology Series 678XX - The popular CTI single channel scan amp used with the 6800 series galvos.

• CL-150 - Laser Artistry Inc. CL-150 single channel scan amp designed to drive G100PD and G120D galvos at speeds up to 18K

• Coherent CR52 and CR54 laser manuals in .pdf format

• Cyonics 2201 manual - Click to view in .pdf format

• Cyonics/Uniphase 2201 Start Card (Rev 6) - Schematic

• DLT 9370 - Divine LightWave technology single axis scan amp for use with CTI6800 series galvos

• G100D - Pinout and wire colours for the General Scanning G100PD galvanometers - contributed by O. Steven Roberts

• G120D - Pinout and wire colours for the DB15 connector on General Scanning G120D and G120-DT galvanometers

• General Scanning A102 - Single axis, open loop, scanner amplifier

• General Scanning A660 - Single axis closed loop, scan amplifier

• General Scanning G100 series - Dimension drawings as a .DOC file (contributed by Albert at PsyTeknology).

• General Scanning GM20 - Pinout for the GM20 actuator (contributed by Mark Edgar)

• GPD-8 - Precision Projection Systems GPD-8 eight channel unipolar actuator drive card for use with GM20 or MFE  R4-077 actuators.

• ILDA DB25 connector - This is NOT the official ILDA document - Visit the ILDA site at http://www.laserist.org/ilda/ to check for any updates

• Laser Fantasy - Three channel scan amp card for closed-loop galvos

• Laser Studio UK - Formerly Laser Systems 12K scanner drive card photo, pinout and schematic.

• Logic Systems DMX - PDF manulas for the Logic Systems series of DMX interface cards

• LM22SDA - Lasermedia dual channel drive amplifier for G100PD type galvos

• MediaLas CatSafe - Scanner failure detection board.

• MediaLas CatWeazle LCII  - Dual channel scan amp board.

• MediaLas STP8 - Actuator and reversing instructions

• MFE R4-077 and R4-155 - Data Sheet

• MVM-S - Pinout for the 36 pin edge connector on the standard MVM eight channel PCAOM driver card

• MVM-N - Pinout for the edge connector on the new MVM eight channel PCAOM driver card with on-card switches and jumpers

• NEOS DB9 - Pinouts for the DB9F connector on the NEOS four channel PCAOM driver

• NEOS DB25 - Pinouts for the DB25 connector on the NEOS eight channel PCAOM driver

• Pangolin LD400 DB25 connector - Pinout for the Pangolin Amiga based LD400 QuadMod16 interface card

• Pangolin LD-Pro DB25 connector - Pinout for the DB25 and 50 pin connectors on the QuadMod32 interface card

• Pythan - Laser and PSU schematics as a .PDF file - Courtesy of Logic Systems

• Tropel - Card edge connector pinout for the Tropel single channel scan drive amp - contributed by O. Steven Roberts

• X-29 Connectors - New Method Lasers connectors on the full-slot length and 3/4 length interface cards

DISCLAIMER: Some of the information in the Backstage area is provided by the persons or companies named on the relevant page(s). Laser F/X does NOT endorse or recommend any products/services and is NOT responsible for the technical accuracy of the information provided.  We provide this information as a service to laserists using the Backstage area. 

 [ Introduction - System Design - Scanning Systems - Support Equipment - Laser Graphics - Show Production - Pinouts ]